The achievable refresh rate depends on the number of channels and the output type.Ī value of 0 disables the output, the default value is 30 Hz. It determines at what frequency the DMX output is refreshed. This is used regardless of the thing(s) that are associated to the channel.Īll bridges can make use of the refreshrate option. This list follows the format of the thing channel definition. Poynton, C.A.: “Gamma” and its Disguises: The Nonlinear Mappings of Intensity in Perception, CRTs, Film and Video, SMPTE Journal Dec. Since the brightness perception of the human eye is not linear, all bridges support applycurve, a list of channels applycurve that have a CIE 1931 lightness correction (cf. You have to add all bridges and things manually. # Discoveryĭiscovery is not supported at the moment. If any of the DMX channels in a chaser receives a command from another thing, the status of the chaser is updated to OFF.Ĭhaser things define a control channel that can be used to dynamically change the chasers fade configuration. If the thing receives an ON command all running fades in all channels are either suspended (if resumeAfter is set to true) or cleared and replaced with the fades defined in this thing.Īn OFF command stops the fades and either restores the previously suspended fades (if resumeAfter is set to true) or just holds the current values. It can contain one or more DMX channels and binds to Switch items only. The second one is the tunable white thing, it allows to control the color temperature of lamps with seperate DMX channels for cool white and warm white. One is the color thing, it can be bound to Switch, Dimmer or Color Items and is best used for RGB lamps. There are two other things similar to the dimmer thing. If more than one DMX channel is defined, the item will be updated according to the state of the first DMX channel.

It can be bound to Switch and Dimmer items. # ThingsĪ dimmer can contain one or more DMX channels. The sACN bridge supports both, unicast and multicast.Īdditionally Lib485 devices are supported via the Lib485 bridge. The ArtNet bridge can only be operated in unicast mode (broadcast mode is not supported as the specification recommends using it if more than 40 nodes are connected, which is unlikely in the case of a smarthome). Two DMX over Ethernet devices are supported as DMX output: ArtNet and sACN/E1.31. There are different output devices supported as well as Dimmers and Chasers.Įach output device (bridges) is representing exactly one universe, each thing is bound to a bridge.Īt least one bridge and one thing is needed for the binding to work properly.

Loxone dmx dimmer